How To Reset Oil Change Light On Dodge Journey?

How To Reset Oil Change Light On Dodge Journey:

Start by sitting in the driver’s seat of your Dodge Journey and make sure that all the doors are closed.
Insert the key into the ignition and turn it to the "ON" position without starting the engine.
Locate the "STEP" button on the instrument cluster. It is usually located on the left side of the steering wheel.
Press and hold the "STEP" button for about 10 seconds until the oil change light starts flashing.
Release the "STEP" button and then immediately press and hold it again for another 10 seconds.
After holding the button for 10 seconds, the oil change light should stop flashing and reset.
Turn off the ignition and remove the key from the ignition switch.
Start your Dodge Journey and make sure that the oil change light is no longer illuminated.
Congratulations! You have successfully reset the oil change light on your Dodge Journey.

Remember to reset the oil change light every time you change the oil in your vehicle to ensure accurate maintenance reminders.

Key Takeaways

The oil change light on a Dodge Journey can be reset by following a specific process using the instrument cluster and a reset button.
The oil change light indicator alerts when it’s time to change the oil and monitors oil level and conditions to calculate replacement time.
The reset button or switch for the oil change light is usually located near the steering wheel and may have an image of a wrench or oil can.
It is important to regularly check the owner’s manual for oil change intervals, use high-quality motor oil, and replace the oil filter during each oil change to prevent the oil change light from coming on.

Table of Contents

Toggle

Understand the Oil Change Light Indicator

To reset the oil change light on your Dodge Journey, you’ll need to understand how the oil change light indicator works and where it is located in your vehicle. The oil change light indicator is a warning system that alerts you when it’s time to change your car’s oil. It monitors the engine oil level and calculates when it needs to be replaced based on factors such as mileage and driving conditions.

To check the engine oil level, locate the dipstick under the hood of your Dodge Journey. Pull out the dipstick, wipe it with a clean cloth, reinsert it fully, and then remove it again to read the oil level.

As for how often you should change your car’s oil, it depends on various factors such as driving habits and manufacturer recommendations.

Once you understand how the oil change light indicator works and have checked your engine oil level, you can proceed to locate the reset button or switch.

Locate the Reset Button or Switch

First, locate the little button or switch that will help you with this. The reset button for the oil change light on a Dodge Journey is typically located on the dashboard near the steering wheel. It is usually marked with an image of a wrench or an oil can. However, it’s important to note that the exact location may vary depending on the year and model of your vehicle.

If you are having trouble locating it, consult your owner’s manual for specific instructions. Additionally, some common issues with resetting the oil change light include not pressing and holding the reset button long enough or not following the correct sequence of actions.

Understanding how to locate and properly use this reset button is crucial in order to successfully reset your oil change light and ensure optimal vehicle performance.

Next, follow the step-by-step process to reset the light…

Follow the Step-by-Step Process to Reset the Light

Now, let’s dive into the simple process of getting that pesky indicator light to disappear. To reset the oil change light on your Dodge Journey, follow these step-by-step instructions:

Locate the Reset Button or Switch: The reset button is usually found on the instrument panel or steering wheel controls. Refer to your vehicle’s owner’s manual if you’re having trouble finding it.
Follow the Step-by-Step Process: Once you’ve located the reset button, follow this process:

Turn on your ignition (but don’t start the engine)
Press and hold down the reset button for approximately 10 seconds
Release the button when you see the oil change light start flashing or turning off

Troubleshooting Oil Change Light Issues: If your oil change light doesn’t reset after following these steps, there could be a few common reasons:

Low oil level in your engine
Faulty sensor or wiring issue
Incorrect resetting procedure

To confirm that the light has been successfully reset and avoid any potential issues, refer to our next section about ‘confirming the light has been successfully reset’ without writing ‘step’.

Confirm the Light has been Successfully Reset

To confirm that the light has been successfully reset, follow these steps:

Start your Dodge Journey and allow the engine to run for a few minutes.
Check the dashboard for any warning lights or indicators.
Look specifically for the oil change light that you reset.
Ensure that the light is no longer illuminated.
If the light is still on, repeat the reset process or consult your vehicle’s manual for further instructions.

Remember, it’s crucial to troubleshoot any potential issues that may arise in the future. Many people mistakenly believe that oil change lights only indicate the need for an oil change. However, these lights can also be triggered by low oil pressure or a malfunctioning sensor. To avoid unnecessary trips to the mechanic, take the time to familiarize yourself with your vehicle’s manual and learn how to troubleshoot different scenarios.

By understanding the various causes behind this pesky light, you can take necessary precautions and prevent it from coming on again.

Tips to Prevent the Oil Change Light from Coming On

To prevent the oil change indicator from coming on, here are some tips to follow:

Regularly check your vehicle’s owner manual for recommended oil change intervals.
Use high-quality motor oil that meets the manufacturer’s specifications.
Replace the oil filter during each oil change to ensure proper filtration.

Regular oil changes are vital because they help lubricate the engine components, reduce friction, and remove contaminants. Neglecting this maintenance can lead to engine wear, decreased fuel efficiency, and even costly repairs.

By staying proactive with scheduled oil changes, you can prevent unnecessary trips to the mechanic and enjoy a smoother driving experience in your Dodge Journey.

Frequently Asked Questions

How often should I reset the oil change light on my Dodge Journey?

How often should you reset the oil change light on your Dodge Journey? The recommended oil change intervals for a Dodge Journey are every 5,000 to 7,500 miles. Are you keeping up with this schedule?

Can I reset the oil change light without locating the reset button or switch?

To reset the oil change light without locating the reset button or switch on your Dodge Journey, you can try alternative methods. These may include disconnecting the car’s battery for a few minutes or using a diagnostic tool to clear the light.

What happens if I don’t reset the oil change light after an oil change?

If you neglect to reset the oil change light after an oil change, consequences await. Ignoring this vital step will lead to confusion and potential engine damage. So don’t underestimate the importance of resetting that pesky light!

How can I tell if the oil change light has been successfully reset?

To check if the oil change light has been successfully reset, start by turning on the ignition without starting the engine. Look for the oil change light on the instrument cluster – if it doesn’t illuminate, it means the reset was successful. If it still remains lit, troubleshoot by checking the oil level and following the vehicle’s manual for further instructions.

Are there any other maintenance lights on the Dodge Journey that I should be aware of?

To reset maintenance lights on your Dodge Journey, you can follow these steps: 1) Turn the ignition switch to the ON position without starting the engine. 2) Fully depress the accelerator pedal slowly three times within 10 seconds. The other maintenance lights on Dodge Journey include the Service Required light and the Tire Pressure Monitoring System (TPMS) light.

Conclusion

In conclusion, resetting the oil change light on your Dodge Journey is a simple process that can be easily accomplished. By understanding the indicator and locating the reset button or switch, you can follow the step-by-step process to successfully reset the light.

Confirming that the light has been reset ensures that your vehicle’s maintenance schedule remains accurate. Additionally, implementing preventive measures such as regular oil changes will help prevent the oil change light from coming on frequently, keeping your Dodge Journey running smoothly like a well-oiled machine.